Column structure strengthening with FRP (Fiber Reinforced Polymer) due to story addition

  • I Wayan Maesa Andreasnata Civil Engineering Department, Universitas Warmadewa, Denpasar, 80235, Indonesia
  • I Nengah Sinarta Civil Engineering Department, Universitas Warmadewa, Denpasar, 80235, Indonesia
  • Ni Komang Armaeni Civil Engineering Department, Universitas Warmadewa, Denpasar, 80235, Indonesia
  • I. P. Ellsa Sarassantika Civil Engineering Department, Universitas Warmadewa, Denpasar, 80235, Indonesia
  • Dang Thanh Trung Civil Engineering Department, National Central University, Taoyuan, 32001, Taiwan (R.O.C)
  • Cintantya Budi Casita Civil Engineering Department, Universitas Pembangunan Nasional “Veteran”, Surabaya, 60294I. Indonesia
  • Roro Sulaksitaningrum Civil Engineering Department, Universitas Negeri Malang, 65145, Indonesia
  • Sudarno P. Tampubolon Civil Engineering Department, Universitas Kristen Indonesia, Jakarta, 13630, Indonesia
DOI: https://doi.org/10.22225/jipe.1.1.2022.38-45

Abstrak

This study focuses on strengthening scheme of an existing structure with added story. The addition of a new story increases gravitational loading, which affects the seismic and wind responses of the structure and, as a consequence, the loading combination. To ensure the structure’s capacity requirement, the strengthening scheme uses CFRP (Carbon Fiber Reinforced Polymer). In order to adequately define the structure's performance, a series of structural analyses were performed. The structure's state before and after story addition, subsequently the state after CFRP strengthening, were evaluated. It is demonstrated that the additional story to the structure causes an exceedance in internal forces; however, the strengthening with CFRP is sufficient to withstand these forces, proving that the strengthening scheme is effective and beneficial.

Referensi

M. H. Chey, J. G. Chase, J. B. Mander, and A. J. Carr, “Innovative seismic retrofitting strategy of added stories isolation system,†Front. Archit. Civ. Eng. China, vol. 7, no. 1, pp. 13–23, 2013.

E. Nehe, P. Simanjuntak, and S. P. Tampubolon, “Evaluation of the performance of high-rise building structures with plan ‘H’ shaped for earthquake with height increase (Case study: Apartment Urban Sky-Bekasi),†IOP Conf. Ser. Earth Environ. Sci., vol. 878, no. 1, 2021.

I. N. Sinarta and I. M. B. Pinandika, “Comparison Of Pushover Method And Direct Displacement Method In Earthquake Load Analysis With Performance-Based Design Concepts,†Ukarst Univ. Kadiri Ris. Tek. Sipil, vol. 4, no. 2, 2020.

C. B. Casita, I. P. E. Sarassantika, and R. Sulaksitaningrum, “Behaviour of Rectangular Concrete Filled Tubes and Circular Concrete Filled Tubes under Axial Load,†J. Appl. Sci. Manag. Eng. Technol., vol. 1, no. 1, pp. 14–20, 2020.

I. P. E. Sarassantika and I. B. G. P. Putra, “The Importance of Awareness of Heritage Building’s Seismic Behaviors : Specific on Pagoda-Type Structure,†J. Infrastruct. Facil. Asset Manag., vol. 2, no. 1, 2020.

I. P. Ellsa Sarassantika, “Perencanaan Gedung the Samator Superblock dengan Elemen structure beton pratekan parsial paska tarik,†Institut Teknologi Sepuluh Nopember, 2015.

S. P. Tampubolon, C. Y. Wang, and R. Z. Wang, “Numerical simulations of the bond stress-slip effect of reinforced concrete on the push over behavior of interior beam-column joint,†IOP Conf. Ser. Mater. Sci. Eng., vol. 725, no. 1, 2020.

D. R. Sahoo and D. C. Rai, “Design and evaluation of seismic strengthening techniques for reinforced concrete frames with soft ground story,†Eng. Struct., vol. 56, pp. 1933–1944, 2013.

R. Sulaksitaningrum et al., “The optimal damper placement configuration for three-dimensional RC building,†IOP Conf. Ser. Mater. Sci. Eng., vol. 669, no. 1, 2019.

I. P. Ellsa Sarassantika, I Ketut Yasa Bagiarta, and I Gusti Nyoman Putra Wijaya, “Peningkatan Performa Seismik pada Sistem Struktur dengan Kombinasi Dinding-Gap-Damper,†in Konferensi Nasional Teknik SIipil ke-13 (KoNTekS-13), 2019, vol. II, no. September, pp. 19–21.

I. P. E. Sarassantika and H.-L. Hsu, “Improving brace member seismic performance with amplified-deformation lever-armed dampers,†J. Constr. Steel Res., vol. 192, no. August 2021, p. 107221, 2022.

B. A. Tayeh, M. A. Abu Maraq, and M. M. Ziara, “Flexural performance of reinforced concrete beams strengthened with self-compacting concrete jacketing and steel welded wire mesh,†Structures, vol. 28, no. October, pp. 2146–2162, 2020.

R. El-Hacha, R. Wight, and M. Green, “Prestressed fibre-reinforced polymer laminates for strengthening structures,†Prog. Struct. Eng. Mater., vol. 3, no. 2, pp. 111–121, 2001.

F. Di Trapani, M. Malavisi, G. C. Marano, A. P. Sberna, and R. Greco, “Optimal seismic retrofitting of reinforced concrete buildings by steel-jacketing using a genetic algorithm-based framework,†Eng. Struct., vol. 219, no. April, p. 110864, 2020.

M. M. Fayyadh and H. A. Razak, “Externally bonded frp applications in rc structures: A state-of-the-art review,†Jordan J. Civ. Eng., vol. 15, no. 2, pp. 157–179, 2021.

“FRP Reinforcement for Concrete Structures: State-of-the-art of Application and Design,†Eng. Struct. Technol., vol. 5, no. 4, pp. 147–158, 2013.

X.-L. Zhao, Y. Bai, R. Al-Mahaidi, and S. Rizkalla, “Effect of Dynamic Loading and Environmental Conditions on the Bond between CFRP and Steel: State-of-the-Art Review,†J. Compos. Constr., vol. 18, no. 3, 2014.

A. Siddika, M. A. Al Mamun, W. Ferdous, and R. Alyousef, “Performances, challenges and opportunities in strengthening reinforced concrete structures by using FRPs – A state-of-the-art review,†Eng. Fail. Anal., vol. 111, no. February, p. 104480, 2020.

A. W. Al Zand, W. H. W. Badaruzzaman, A. A. Mutalib, and S. J. Hilo, “Rehabilitation and strengthening of high-strength rectangular CFST beams using a partial wrapping scheme of CFRP sheets: Experimental and numerical study,†Thin-Walled Struct., vol. 114, no. February 2016, pp. 80–91, 2017.

R. Ismail, R. S. M. Rashid, F. A. A. Zakwan, and F. Hejazi, “Experimental study of circular hollow reinforced concrete column strengthened with partial Carbon Fibre Reinforced Polymer (CFRP) confinement,†IOP Conf. Ser. Mater. Sci. Eng., vol. 615, no. 1, 2019.

A. S. Abdel-Hay, “Partial strengthening of R.C square columns using CFRP,†HBRC J., vol. 10, no. 3, pp. 279–286, 2014.

Computer and Structures.Inc (CSI), “ETABS.†Computer and Structures, Inc (CSI), 2013.

Badan Standardisasi Nasional, “Tata Cara Perencanaan Ketahanan Gempa Untuk Struktur Bangunan Gedung dan Non Gedung,†Sni 17262019, no. 8, p. 254, 2019.

2020 SNI 1727, “Beban desain minimum dan Kriteria terkait untuk bangunan gedung dan struktur lain 1727:2020,†Badan Standarisasi Nas. 17272020, no. 8, pp. 1–336, 2020.

Badan Stadandarisasi Nasional-BSN, SNI 2847-2019 : Persyaratan beton struktural untuk bangunan gedung dan penjelasan, no. 8. 2019.

ACI Committee 440, “Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures Reported by ACI Committee 440,†2002.

Diterbitkan
2022-04-18
Terbitan
Vol 1 No 1 (2022)
Bagian
Articles

Authors who publish with this journal agree to the following terms:

1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).

Abstrak viewed = 344 times
PDF (English) downloaded = 704 times